DDB series dry pumps (10MPa) an overview of 
 DDB series of multi-point dry pumps for lubrication frequency is very low, lubrication points not more than 50 points, the nominal pressure for the 10MPa multi-line dry oil lubrication system. Directly or through-line piece for the device to send grease to the oil to the lubrication points, crushing machine, forming machine tools, terminal line hanging, presses, etc., especially suitable for small stand-alone device. 




 Second, the technical parameters 

 Model Nominal pressure (MPa) per port to the oil to oil the number of ml / / min oil storage volume had l motor power (kW) Weight (kg) 
 DDB-10 10 10 0-0.2 13 7 0.37 19 
 DDB-18 18 23 0.75 75 
 DDB-36 36 80 
 The use of media for Cone Penetration of not less than 265 (25 ° C, 150g) the 1/10mm's grease (NLGI0 # ~ 2 #). Operating temperature 0 to 40 ℃. 

 Third, the Dimension 

 DDB,-10 multi-point dry pump DDB, 18,, DDB,-36 multi-point dry pump 

 Fourth, the model label instructions 


 Fifth, instructions for use 
 1, the series dry pumps should be installed at the appropriate ambient temperature, dust, easy to fill fat, adjustment, inspection, maintenance and so on convenient occasions. 
 DDB, Series dry pumps use a deceleration before the first box to join the surface of the provisions of the HL-20 gear oil to the oil standard. 
 3, fill grease to the inside of the dry pump oil storage must use the SJB-D60 manual pumps or DJB-200 electric fuel pumps from the oil storage refueling port, note that no grease in the inside of the oil storage is prohibited to start the motor operation. 
 4, the the jerry wall spin spin to the licensing requirements to carry out the electrical wiring shall not reverse. 
 5, the fuel filler filter accuracy of not less than 0.2mm, should be cleaned regularly. 
 Dry pump should always be kept clean, is strictly prohibited Uncovery fill grease to avoid dirt into the pump body, affecting the normal work.