The XYZ-G-type thin oil station (0.4MPa), conditions of use 
 This product is suitable for thin oil circulation lubrication system, the working medium for the turbine oil, 20 to No. 25 machine oil and rolling oil, kinematic viscosity grades N460 and N22 ~ (equivalent to ISO VG22 VG460). 
 Diluted oil station of the nominal supply pressure of 0.63MPa; filtration precision 0.08 ~ 0.12mm; cooling water temperature ≤ 28 ℃; cooling water pressure 0.2 ~ 0.3MPa; heat exchanger oil inlet temperature of 50 ° C, the temperature drop of 7 ~ 8 ℃; The use of steam heating steam pressure of 0.2 ~ 0.4MPa. 
 Second, the principle 
 Work, the oil from the tank by a gear pump sucked out through the check valve, double tube net oil filter, and tube oil cooler, directly to the lubrication point. Maximum supply pressure of the filling stations 0.4MPa, the minimum supply pressure is 0.1MPa, the use of pressure determined by adjusting the safety valve according to the requirements of the lubrication points, when the working pressure of the petrol station more than a safety valve set pressure relief valve will automatically open, the excess oil back into the tank. Normal working hours, the pump a single work, a spare. Sometimes, equipment, fuel consumption due to some reason need to increase the system pressure drop down to the setting value, adjust the pressure controller, the standby pump is automatically turned on, working together with the working pump until the pressure is normal, the standby pump automatically stops. If the oil pressure continued to decline to another setting value, then through another pressure controller regulation, issued an accident alert. 
 Binoculars mesh oil filter, the filter element, filter element standby at the entrances to access the differential pressure transmitter device, when the pressure exceeds 0.15MPa (≥ 250L/min lubrication oil station 0.15 ~ 0.1MPa), manual switching, spare filter work, remove the original filter, clean or replace the filter. 
 The petrol station outlet connected to pressure electric contact thermometer, oil temperature requirements, it is set to the highest and lowest two boundaries. At low temperatures, the signal light, manually open the heater for heating, when the oil temperature rise of the highest point, automatically cut off the heater stopped heating; oil inlet temperature is high, the alarm and open the cooler. 
 ≥ of 250L/min thin oil station, the lubricating oil in the steam heating tank, the dashboard is still a detection cooler access to water differential pressure instrument, and its main components are installed another on the basis of; ≤ 125L/min thin oil The station parts are housed in the tank for the overall structure. 

 Third, the structural characteristics 
 a) provided with a standby pump, to ensure continuous fuel supply to the lubrication points. 
 b) filter placed in the cooler before you can improve filtering capacity; more suitable for higher viscosity of the lubricating medium. 
 c) using a binocular filter, stopping from time to carry out the cleaning and replacement of the filter. 
 d) The tube oil cooler, cooling effect, resistance, ease of maintenance. 
 e) oil return with magnetic mesh filter, adsorption to remove iron particles in the fluid, to ensure the cleanliness of the oil and improve the life of lubricated components. 
 f) with the instrument panel and electric control box, observe the operating parameters can achieve automatic control and accident alarm. 

 Fourth, the technical parameters 
 Type the XYZ the XYZ and the XYZ the XYZ the XYZ the XYZ the XYZ the XYZ the XYZ the XYZ the XYZ the XYZ 
 -6G-10G-16G-25G-40G-63G-100G-125G-250G-400G-630G-1000G 
 Oil pressure (MPa)